Tutorial Your first week in Laramin Step 2 of 11 · Stage 1: Sign in safely. 0 of 9 steps done Exit tutorial

Set up two-factor authentication

Protect your account with a one-time code from an authenticator app, and keep your recovery codes somewhere safe.

Why this step

A code from your phone stops anyone who learns your password. It takes two minutes, once.

Today you only need:

Applies to
Core 12.0 and later
Who can do this
Administrator, Team member, Platform owner
Where
Account menu › Profile › Security

With two-factor authentication (2FA) on, Laramin asks for a 6-digit code from your authenticator app each time you sign in, after your password or after you sign in with Google or another provider.

Before you start

  • Install an authenticator app on your phone. Any app that scans a QR code and shows 6-digit time-based codes (TOTP) works. Laramin doesn't require a particular one.
  • Have somewhere safe to store your recovery codes, such as a password manager.

Turn on two-factor authentication

  1. In the header, select your avatar to open the account menu.
  2. Select Profile.
  3. Select Security. Under Two-Factor Authentication, the status reads Disabled.
  4. Select Enable 2FA. A QR code and a Setup Key appear.
  5. Scan the QR code with your authenticator app. If you can't scan it, type the Setup Key into the app instead.
  6. In Confirmation Code, enter the 6-digit code the app shows.
  7. Select Confirm.

You see "Two-factor authentication enabled." The status changes to Enabled, and the account menu shows 2FA on.

Careful: 2FA isn't on until you confirm a code. While you are between the two, the account menu shows 2FA pending and sign-in doesn't ask for a code yet.

Save your recovery codes

Right after you confirm, the Recovery Codes panel shows eight codes.

  1. Copy the codes and store them somewhere safe, away from your phone.
  2. To see them again later, select Show Recovery Codes.

Each code works once. Use one to sign in if you lose your phone. To replace all of them with a new set, select Regenerate Recovery Codes. The old codes stop working.

Turn off two-factor authentication

  1. On Security, select Disable 2FA.
  2. Confirm "Disable two-factor authentication? Your account will be less secure."

What happens next

The next time you sign in, Laramin shows Two-Factor Authentication after your password. Enter the code from your app and select Verify. If you sign in with Google or another provider, Laramin shows the same screen when the provider sends you back. See How social sign-in works.

On Social Login 2.1.0 and earlier, signing in with a provider on the web didn't ask for your code. Ask your administrator to update Social Login to 2.1.1.

The mobile app asks for your code too, after your password or social sign-in. You can use a recovery code there instead, and each recovery code works once.

If your administrator has turned on trusted devices, you can select Trust this device on the Sign-In screen. That browser then skips the code until the trust expires.

Check it worked

0 of 2 ticked

Tick each one you can see. Ticks stay on this device; they don't stop you moving on.

Check it worked

Something not right? You can't sign in because you lost your authenticator app

Back
Steps
Mark done